Proudly Australian Made

 AusCruise AC-5CC-Drive by Wire Cruise Control for 12v / 24v Commercial Vehicles

 

 

 

AusCruise have developed our Drive by wire cruise control further so it can be used

on 12v and 24v commercial vehicles.These systems because they are fully

electronic are extremely safe and reliable.

 

These Cruise Control are designed to be Professionally installed, and can be

installed to most light trucks which are 12v vehicles or with the addition

of our special 24v interface to 24v vehicles. The system is fully programmable at

installation with the AusCruise Handheld Diagnostic & Programming Tool.

 

All the Professional range of AUSCRUISE cruise controls use OEM connectors on

there wiring looms for maximum reliability.

With the AC-5CC-DDbW you get a choice of AusCruise Steering Wheel Switch, Stalk

Switch or Dash Switch. You can also use most OEM switch by using an optional

interface module.

 

Switches can be viewed in our gallery ( click on Products )

 

We have currently tested our system on the following Commercial vehicles:

 

1. Renault - Trafic and Master Vans

2. Mercedes - Vito and Sprinters

3. Ford Transit

4. Hino all Models

5. Nissan UD

6. Isuzu

7. Iveco

8. Fuso

9. Hyundai HD45, HD65 & HD75 - Factory looking switches available for these. (Additional Cost)

 

FEATURES

 

    ECU  Speed signal pickup

    SET  - Set cruise control to current speed

    RES  - Resume Cruise control to previous speed

    Resume speed memory even after ignition has been turned off

    ACC - Hold down to accelerate under cruise control

    DEC - Hold down to decelerate under cruise control

    Tap Up Tap Down feature

    Two colour indicator light on most Switches or on Dash. Green = Cruise ON and  Orange = Cruise ENGAGED

    Selection of switches available.

    Diagnostic Mode

    On Road Calibration Mode

    Special drive by Wire Throttle interface module

    Suits both Automatic and manual Transmission vehicles

    Mechanical Clutch switch input.

    Over-Rev (Tacho) input.

    Designed specifically for Drive by wire throttled trucks

    OEM Connectors used on wiring looms

    Australian Designed

    Electronics module manufactured in Australia using state of the art SMT production line.

    Optional Single Speed over speed alert

    Optional Multi-Resume. You can set your 3 favourite speeds into the cruise controls memory

    Optional Multi- Speed Over Speed Alert

    Optional Clutch controlled Coast / Resume to allow gear changing on manual vehicles.

    On board Speed signal buffering

    On board speed signal Dividing

    High input pulse rate , now capable of up to 200,000 Pulses per km on speed input.

    On Board Buzzer for Over Speed Alert.

    Audible chirp from Buzzer when switch buttons are pressed (Programmable)

    Programmable pull-up on Clutch input (makes our cruise control easier to intergrate into vehicle)

    Programmable pull-up on Speed input (makes our cruise control easier to intergrate into vehicle)

    Improved Caliberate Mode - Buzzer chirps as well as LED flaching for Gain setting.

    Current Limiting Protection on Horn Circuit - Improved interfacing with vehicle horn wiring.

 

Please contact us about your nearest Dealer for quotation on the supply and installation of these cruise controls.